What are the buttons on a Jacuzzi for?
This button will control water flow through your jets; some larger tubs can have up to three jet buttons that control different sections of jets within the spa. Many also have different speeds that the pump can send water through the jets at.
How do you turn on an old Jacuzzi whirlpool?
Press the “On/Off” control on the side of the tub to turn on the pump and start the whirlpool jets. Wait for up to a minute while the pump primes. Once the pump is primed, the jets will activate.
Where is the hot tub control panel located?
The topside control panel is the name for the display and controls, on the top-side of the spa, or where you can see them when you’re in the spa. I’m old enough to remember having to get out of the spa to turn up the heater or turn on the air blower, or those sticky hexagonal air buttons.
Why is my Jacuzzi bath not working?
If the jets do not work, clear a blocked water intake of hair and other particles (see below) or replace a broken jet (see below). If the water in your spa or hot tub is too hot or too cold, check to see if the high-limit reset switch has been tripped and, if needed, reset it.
Where is the reset button on a Jacuzzi?
You will find a reset button typically on the heater unit. Usually there is a pilot light. When you’re ready to reset, push the button. Some spa units have a high limit switch which will turn off the spa heater if the thermometer fails.
Why is my Jacuzzi tub not working?
Jets Are Not Working Properly When jets start failing, the most likely case is that your hot tub pump is not working correctly. You will need to diagnose hot tub problems relating to the pump. Check your pump’s priming to make sure it is working properly. Open the access panel and the airlock valve close to the pump.
How do I reset my jetted tub?
How Do I Reset a Jetted Spa?
- Drain the water using the main control panel and turning the valves below. Give it time to drain all of the water; this could take an hour or more depending on the size of your spa.
- Turn your spa off using the main control panel.
- You will find a reset button typically on the heater unit.