Can you run 4 speakers and a sub off a 4 channel amp?

Can you run 4 speakers and a sub off a 4 channel amp?

4 channel amps are great and have a lot of flexibility for the most part. However, they’re intended for use with 4 speakers or 2 speakers and a sub – not both. However, it is possible to wire a 4 channel amp to 4 speakers and a sub!

What size amp do I need for 2 12 subs?

Then determine the amount of power your subwoofers can handle. RMS power handling of a 55 series 12” dual 2 ohm voice coil subwoofer is 400 watts. Two of these subwoofers would mean you need 800 watts of power at to the total circuit impedance.

What Does bridging an amp do?

Bridging an amplifier refers to the process of combining two of four channels into one or two channels with half the ohms. The technique has become very popular among many car owners because it allows amplifiers to send out a more powerful mono signal to the subwoofer or speakers.

What is louder parallel or series?

As a general rule, parallel speakers are louder than series speakers. That’s because: Wiring speakers in series increases the total speaker impedance (Ohms) load, decreasing how much electrical current (amps) can flow. This means the amp or stereo’s power output will be lower.

What sounds better parallel or series?

While most people prefer parallel because the sound is better due to lower resistance, speaker output from series wiring has high mids with more robust sound. If you’re a deep bass fan, then you’ve got a friend in parallel wiring. A combination of the two will also produce a better sound.

What does bridged mean on an amp?

Primarily a live sound term, “bridging” is a means to configure a 2-channel amplifier to drive a single loudspeaker with more power than the two original channels. For example, a 100-watts-per-channel amp may output a single channel of 300 watts after bridging.

How many RCA cables do I need for a 4 channel amp?

As we mentioned above, you will need two RCA cables for a 4-channel amplifier. Each RCA cable will have two signal channels, left and right for your front and rear speakers and left and right for your rear speakers. That way, you’ll get the sound quality you want.