How do I connect to airFiber?

How do I connect to airFiber?

Connect Power over Ethernet to the Data port, and connect an Ethernet cable between your computer and the Management port. Configure the device settings in the airFiber Configuration Interface. Once configuration is complete, disconnect the cables to move the airFiber radios. Pre-assemble the mounting hardware.

What is airFiber antenna?

The airFiber X antenna delivers 2×2, dual-polarity performance. On the right is one example of how the airFiber X antenna with an airFiber X radio can be deployed as endpoints in a backhaul link to deliver bandwidth from a WISP network out to a neighborhood tower.

What is PtMP station?

Point-to-Point (PtP): Connects two locations, usually at a distance of multiple km, essentially forming an Ethernet bridge. Point-to-Multipoint links (PtMP): Connects three or more locations, using one Base Station (or Access Point) and multiple CPE devices (Stations) connected to the Access Point.

How do I setup my af60?

Let the device obtain an IP address and then check the DHCP server to see which IP address was assigned.

1. Launch your web browser.
2. Select your Country and Language.
3. Enter a Username and Password, confirm the Password, and click Save.
4. Click the icon.
5. Configure the following settings:
6. Click Save Changes.

How do I reset my Airfiber?

Interface Description Reset To reset to factory defaults, press and hold the Reset button for more than five seconds while the unit is powered on.

How do I reset my 5xhd Airfiber?

Reset Button To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the device is powered on. Signal 4 LED will light blue when on. Signal 3 LED will light green when on. Signal 2 LED will light yellow when on.

What is the difference between PtP and PtMP?

In a PtP network there is a single station, but in a PtMP there are many stations. If you have multiple locations to connect, a PtMP network is more scalable than multiple individual PtP links. A PtMP network covers a slice of the surrounding area, allowing multiple radios to connect back to a single point.

What is airMAX Ubnt?

AIRMAX TDMA SYSTEM. Optimize Wireless Performance for Outdoor Installations. Ubiquiti Networks™ introduced the airMAX® platform to out-perform traditional, 802.11 Wi-Fi based, Point-to-MultiPoint (PtMP), outdoor networks.

How do I reset my Airfiber 60?

To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the device is powered on. Alternatively, the device may be reset remotely via a Reset button located on the bottom of the Gigabit PoE Adapter.