How do you enter value labels in SPSS?

How do you enter value labels in SPSS?

Display Value Labels in SPSS

1. Click on tab to display Variable View.
2. Identify your variable, click on its cell in the Values column, and then click on the ellipsis.
3. Enter your first coded numerical value where it says Value, and the label you want associated with that value where it says Label.

How do you exclude cases in SPSS syntax?

To delete certain cases from an analysis, use the SELECT IF command and select cases by providing selection conditions. For example, to delete freshmen (grade=1) from an analysis, run this SELECT IF command: SELECT IF (grade=2 OR grade=3 OR grade=4).

What Is syntax SPSS?

What is Syntax? SPSS syntax is a programming language that is unique to SPSS. It allows you to write commands that run SPSS procedures, rather than using the graphical user interface. Syntax allows users to perform tasks that would be too tedious or difficult to do using the drop-down menus.

What are value labels in SPSS?

Value Labels are similar, but Value Labels are descriptions of the values a variable can take. Labeling values right in SPSS means you don’t have to remember if 1=Strongly Agree and 5=Strongly Disagree or vice-versa.

How do I exclude missing data in SPSS?

You can specify the missing=listwise subcommand to exclude data if there is a missing value on any variable in the list. By default, missing values are excluded and percentages are based on the number of non-missing values.

How do I recode string variables?

Running the Procedure

1. Click Transform > Automatic Recode.
2. Double-click variable State in the left column to move it to the Variable -> New Name box.
3. Enter a name for the new, recoded variable in the New Name field, then click Add New Name.
4. Check the box for Treat blank string values as user-missing.
5. Click OK to finish.

How do you display syntax in SPSS?

To tell SPSS to include Syntax in your Output Window, click “Edit” → “Options.” Once you click Options, this window will pop up. Click the “Viewer” tab. On the “Viewer” tab, check the box at the bottom left hand that says “Display commands in the log.”