Why is the back wheel on bike loose?
If it’s wobbling side to side, there are two problems that are possible; Your cup-and-cone bearings could be loose or your wheel could be out of true (slightly buckled.) Take your wheel off and hold the axle. Wobble it up and down a few times.
Why is my wheel hub loose?
Wheel looseness, or also called wheel play, is another common symptom of a bad wheel bearing. As the bearing begins to wear down, they become loose inside the wheel hub and spindle, which makes your vehicle feel loose while steering.
Is it safe to ride a bike with a wobbly wheel?
It depends on the reason for them not being true. A lack of equal tension in the spokes could mean weakness in one (or more) of them – and broken spokes are not a good thing to ignore. You can survive one or maybe two for a short while, but eventually the rim could be in danger of collapsing.
Should my rear cassette wobble?
Should be no wobble , something is amiss . If you do not have the ability to tighten the lock ring on the cassette you should have your LBS have a look at it .
How much should a bike tire wobble?
A little wobble is acceptable and will not be noticed most of the time. And it will not damage the wheel. I would wait until the 3 month tune-up as some other things are likely to need attention by then. Better to be out of a ride once than to be taking it back in every week.
Why does my bike feel wobbly?
Bicycles usually wobble either because of a loose bolt, improper adjustment, or improper spoke tension. Most of these problems can be fixed at home using a spanner, hex keys, or a spoke key depending on the type of wobble you experience.
Can you over tighten rear cassette?
Only thing I’ll add is that it is possible to over-tighten a lockring and damage the freehub. Specifically the DT 240S freehub for Campy. The shoulder/flange the cassette tightens against is very thin metal and I did managed to crack one by overtightening.
How do you fix a loose hub on a bike?
Hold your bike steady, grab the wheel at its highest point and move it from side to side. If it moves at all, sometimes with a clunking noise, your hub is loose. If your hub has press-fit cartridge bearings, it might not have any way of adjusting the hub tension. In that case, you need new bearings.
What happens when the hub is loose on a wheel?
When the hub is loose, the wheel bearings can move from side to side, whether they are ball or cartridge bearings. Even though this is only a small amount of movement, the distance to the rim amplifies the wobble.
What are the symptoms of a loose hub on a motorcycle?
You may not realize that your hub is loose for some time. However, your riding will probably feel “off” – cornering becomes sloppy and descents feel sketchy. On the rear wheel, shifting may be off. You may also feel or hear a “clunk” that seems to be coming from your suspension (fork or shock).
How do you tighten loose bearings on a wheel?
For all other loose hubs, you must tighten the bearings back down. However, it’s easy to overdo this tightening and end up with a wheel that doesn’t spin freely, causing premature bearing wear. Hubs are normally tightened using cone nuts. “Cone” refers to “cup and cone” – the two pieces that loose bearings sit in.