What are ID injectors?
ID1300-XDS – Injector Dynamics. The ID1300x² is an all new injector, designed in partnership with Bosch Motorsport. This collaboration has given us the ability to design a high flow injector with characteristics specific to the needs of the motorsport tuner.
How do I find my injector number?
The majority of diesel injectors are made by Bosch and the part number is usually found on the pin connector unit above the O ring , however on some injectors they will be on the main body. Petrol injectors tend to have part numbers stamped on the side of them.
What do the numbers on fuel injectors mean?
Fuel Injectors are sized by their flow rate. Flow rate is a measurement of how much fuel can be delivered over time. It is listed in pounds per hour (lbs./hr.) or cubic centimeters per minute (cc/min.). The right size injector can supply enough fuel under full load conditions at an 80% duty cycle.
Are ID injectors high impedance?
All Injector Dynamics injectors are high impedance. If your car came with a low impedance injector and a resistor ‘box’, it will need to be bypassed.
How much HP can id1050x handle?
The 1050x Injectors you can do 800whp, but not much more than that.
Are all injectors compatible?
If the body of your car’s injectors is gray, keep in mind: injectors of all releases ARE compatible! So, your car can have injectors with a different release for each cylinder!
What happens if you don’t code injectors?
Non start – In newer systems if you do not code in the injectors the vehicle will not start. Poor / lumpy running – as the injectors are not coded, the ECU will carry on fuelling as if the previous injector was still present, which can cause poor performance.
How many digits are the injector ID code?
In simple terms, if the IMA code is present, then the injector will need coding. The typical code length is 6-10 digits and is located on the injector connector head.
What is the code for a bad fuel injector?
The most common fault codes associated with a clogged fuel injector are P0171 and P0174, which indicates the engine controller is seeing a lean condition. It is also possible to see fault codes for a rich condition if the injector is leaking or not atomizing correctly.
How much HP can stock LS3 injectors handle?
Stock injectors can support 600 NA HP, but DC will be over 80% around the 500-520 mark.
How much HP can 1000cc Injectors handle?
The 1000cc Injectors can support 650+whp.